Long-Lasting Service:
AMSOIL lubricants have a long service life. Non-synthetic lubes can break down from oxidation and heat. When that happens, they sludge-up, form deposits and have to be changed.

AMSOIL lubricants resist breakdown, so they stay intact and run clean. This resistance to heat and oxidation prolongs the service life of AMSOIL synthetic lubricants, significantly
extending drain intervals.

Low Temperature Fluidity/High Temperature Stability:
AMSOIL lubricants resist the effects of heat and cold far better than nonsynthetic lubricants. AMSOIL synthetics will make the difference when starting an engine that’s cold, and cooling an engine that’s hot.

Rust and Corrosion Protection:
AMSOIL contains special additives to prevent rust and corrosion – a vital factor for equipment that sits idle or is stored for part of the year.

Anti-Friction:
AMSOIL lubricants are “super-slippery.” They are extremely effective in reducing friction and drag between moving parts, resulting in reduced wear, more efficient operation and
better fuel economy.

Versatile For Most Applications:
In most cases, AMSOIL lubricants eliminate the need for specialty lubes. AMSOIL products meet or exceed the performance specifications of a wide variety of farm machinery.

Outstanding Performance At Extreme Temperatures

AMSOIL Flows in the Cold
Non-synthetic oils thicken rapidly as the temperature drops. In cold weather, this causes difficult starting as the engine fights to turn over against the semi-solid lubricant. Even
if the engine starts, the cold, thick oil will not circulate immediately, which means some parts of the engine can run for up to five minutes without any lubrication at all.

AMSOIL stays fluid at much lower temperatures. In cold weather, AMSOIL permits easier starting and instant lubrication throughout the entire engine. During starts and warm-ups,
critical engine surfaces slide, protected by a tough, reliable film of oil between them.

AMSOIL Takes the Heat
A hard-working engine generates tremendous heat, a serious problem for non-synthetic lubricants. Oil thickening and oil consumption occur when high temperatures evaporate
the lighter, more volatile portions of petroleum-based oil. Heat also causes oxidation, forming gummy sludges and varnishes.

AMSOIL is heat-stable. AMSOIL resists volatile evaporation and thickening at high temperatures. It resists oxidation and inhibits the formation of engine deposits.

Low volatility means reduced oil consumption. Reduced thickening promotes
better fuel economy (because thick oil causes internal engine resistance) and better engine protection, especially during cold start-ups when thick oil doesn’t circulate properly.

AMSOIL actually cools hot engines and gear boxes too, reducing stress on components nd
extending equipment life.

Availability:
AMSOIL synthetic motor oils are available in quart, gallon and 2.5-gallon containers, and 30- and 55-gallon drums.

Performance:
AMSOIL Synthetic Diesel Oils are fuel efficient, super-heavy-duty, multi-viscosity lubricants for use in light and heavy-duty diesel and gasoline engines. Their synthetic base stocks
and proven long-life additives assure performance, economy, and outstanding protection over extended drain intervals.

Because they meet and exceed the lubrication demands of virtually every light and heavy-duty diesel and gasoline engine, farmers with a variety of vehicles need only stock one of
these “all-engine” oils for their vehicles and equipment.

Warning: include(/var/www/vhosts/oilhelp.com/httpdocs/includes/include_die.php) [function.include]: failed to open stream: No such file or directory in /home/oilhelp/public_html/includes/include_app_farming.php on line 156

Warning: include() [function.include]: Failed opening '/var/www/vhosts/oilhelp.com/httpdocs/includes/include_die.php' for inclusion (include_path='.:/usr/lib/php:/usr/local/lib/php') in /home/oilhelp/public_html/includes/include_app_farming.php on line 156

(API GL-5/MT-1) Extre me Pressure Synthetic Gear Lubes 75W-90, 80W-90, 75W-140, 80W-140

Farmers need to cut costs wherever and whenever they can. AMSOIL Synthetic Gear Lubes save money by making drive trains operate as efficiently as possible, for as long as possible.

Reduce Friction:
AMSOIL Synthetic Gear Lubes are blended with outstanding anti-friction properties. Friction in transmissions and differentials steals energy. Lost energy translates into less power and poor fuel economy. The superior “slipperiness” of AMSOIL Gear Lubes makes gear-boxes run cooler and easier. Components move with less resistance, even under heavy loads. Transmission parts last longer and the saved energy is transmitted to the
wheels, allowing maximum use of every gallon of fuel.

Reduce Wear:
The outstanding extreme pressure and anti-wear properties of AMSOIL Synthetic Gear Lubes keep wear at an absolute minimum. The results: greater equipment reliability and less money spent on repairs, replacement parts, and costly down-time. AMSOIL helps keep equipment in the field and out of the shop!

Improves Performance and Reliability. . . Saves Time and Money SVG-16 ATH-55 HDD-30

Most hydraulic/transmission failures are caused by contamination or breakdown of the hydraulic fluid. Excess heat is a major enemy of hydraulic/transmission fluids. Non- synthetic hydraulic fluids are likely to oxidize when exposed to the extreme environment of tractor transmissions and hydraulic systems. Oxidation leads to the formation of acids, varnish and sludge deposits. This can thicken oil, reduce lubricating abilities, accelerate wear, damage hoses and lead to further overheating and catastrophic component failures.

AMSOIL Tractor Hydraulic/ Transmission Oil (ATH) is made up of thermally stable and chemically resistant synthetic base stocks, and premium- quality additives.

AMSOIL ATH is highly resistant to heat breakdown and chemical changes. It is a better "carrier” for heat transfer, so equipment runs 20° to 50° cooler. All of this means more
efficient and economical operation, with less maintenance and profit-stealing downtime.

The durability of AMSOIL ATH allows drain intervals two to three times longer than those of conventional fluids. This saves time, effort and money because you buy fluid less often.
Cooler operation with AMSOIL ATH increases fuel economy and equipment life, especially for hoses, which are susceptible to heat damage.

AMSOIL ATH also provides superior protection against rust and corrosion, a critical form of protection during equipment storage.

AMSOIL Synthetic Tractor Hydraulic/ Transmission Oil is “all weather” oil that operates over a wide range of temperatures. It has a high viscosity index to maintain its lubricity at high
operating temperatures, and it flows at temperatures as low as -47°F for improved equipment operation and wear protection. It exceeds the most demanding “all weather” specifications of both Ford New Holland FNHA 2-C-200 & 2-C-201 and John Deere J20C & J20D, eliminating the need for seasonal oil changes.

(1) Quality: a full line of synthetic lubricants and ultra-fine filters whose performance and durability is second to none. AMSOIL quality means increased reliability, more economical operation, and less maintenance and downtime. Using AMSOIL saves time, aggravation and MONEY!

(2) Service: conscientious and dedicated attention to detail from AMSOIL INC. and your servicing AMSOIL Dealer.

Your independent AMSOIL Dealer uses AMSOIL products himself, so he knows the benefits and is eager to show you how you can profit using AMSOIL. His confidence and enthusiasm are direct results of the quality of AMSOIL products and the integrity of AMSOIL INC.

AMSOIL INC. has a toll-free number so customers can order AMSOIL products directly, and offers a convenient credit plan for commercial accounts. The AMSOIL Technical Services Department is always ready to answer your lubrication or filtration questions.

(3) Expertise: the know-how that comes from three decades of experience tailoring AMSOIL products to meet customers’ needs. AMSOIL INC. manufactured the first synthetic motor oil in the world to pass American Petroleum Institute (API) service qualification tests. AMSOIL is “The First in Synthetics.” The leadership of AMSOIL in developing state-of-the-art synthetic lubrication and filtration solutions provides the consumer with a choice found nowhere else — the best lubrication that science has to offer.

If you’re looking for ways to add
PROFIT to your business by cutting your
operating costs, come to AMSOIL!

Wallace Dunn, Richfield, KS: I started using AMSOIL in the spring of 1983. Using AMSOIL SAE 30 Diesel Oil and the AMSOIL By-Pass Oil Filter, we run 900 hours between oil changes on the 160 HP Case and 700 hours in our 120 HP Deutz Allis air-cooled. I use the AMSOIL 20W-50 Synthetic Oil in my Massey 510 combine on a two-year oil change schedule. I am very pleased I was introduced to AMSOIL Products.

Harold Isaac, Hooker, OK: I use AMSOIL Synthetic Engine Oil, Synthetic Multi- Purpose Hydraulic Fluid and the AMSOIL 80W-90 Synthetic Gear Lube in my two Deere tractors, my 855 Steiger and my N6 Allis combine. I also use the AMSOIL By-Pass Oil Filters and change oil once a year. Our farm uses nothing but AMSOIL and we are happy with the results. There is a large difference in performance between petroleum oil and AMSOIL, as well as a lot of money and time saved.

Warren Bowker, Richfield, KS : I started using AMSOIL in 1975, and right off I could see the difference, so I put it in everything on the farm. I use AMSOIL 10W-40 Synthetic Oil in my six tractors – three Internationals and three John Deeres – and in my
Massey combine. We use the AMSOIL 15W-40 in our two semis, a Mack and a Detroit engine, along with the related AMSOIL Synthetic Lubes in the transmissions and differentials. AMSOIL 75W-90 Gear Lube is in the irrigation gear heads and this has lowered the fluid temperatures considerably. We are 100% AMSOIL and plan on staying that way.

Steve Patterson, Copeland, KS: One of our irrigation engines runs all year with no oil
change using AMSOIL and AMSOIL By-Pass Oil Filter. AMSOIL 75W-90 Synthetic Gear Lube is used in the gear heads on a five-year change period. My records show that I’m saving 58 cents on the dollar on lube cost between the cost of AMSOIL and petroleum lubes.

Francis and Rock Ormiston, Kismet, KS:
We have been using AMSOIL totally since 1974. We farm separately but do, on occasion, interchange some machinery. Between us we have four large 4-wheel drive John Deere tractors from 200 to 400HP. We use AMSOIL in all the tractors and the combine, and the AMSOIL By-Pass Filters, too. We change oil once a year in the early spring. We have not figured our real savings by using AMSOIL, but for sure it’s a strong
50 cents on the dollar over petroleum oil, and saving a lot of labor on very little downtime. There is no way we could afford to go back to petroleum, even if it was
given to us free.